Defense Federal Acquisition Regulation Supplement; Nonavailability Exception for Procurement of Hand or Measuring Tools (DFARS Case 2011-D025)
DoD is issuing an interim rule to implement section 847 of the National Defense Authorization Act for Fiscal Year 2011. Section 847 provides a nonavailability exception to the requirement at 10 U.S.C. 2533a (Berry Amendment) to acquire only domestic hand or measuring tools.
Table of Contents
- I. Background
- II. Executive Order 12866
- III. Executive Order 13563
- IV. Regulatory Flexibility Act
- V. Paperwork Reduction Act
- VI. Determination To Issue an Interim Rule
Submit comments identified by DFARS Case 2011-D025, using any of the following methods:
Submit comments via the Federal eRulemaking portal by inputting “DFARS Case 2011-D025” under the heading “Enter keyword or ID” and selecting “Search.” Select the link “Submit a Comment” that corresponds with “DFARS Case 2011-D025.” Follow the instructions provided at the “Submit a Comment” screen. Please include your name, company name (if any), and “DFARS Case 2011-D025” on your attached document.
○E-mail: firstname.lastname@example.org. Include DFARS Case 2011-D025 in the subject line of the message.
○Mail: Defense Acquisition Regulations System, Attn: Amy G. Williams, OUSD (AT&L) DPAP/DARS, Room 3B855, 3060 Defense Pentagon, Washington, DC 20301-3060.
Comments received generally will be posted without change to http://www.regulations.gov, including any personal information provided. To confirm receipt of your comment(s), please check http://www.regulations.gov approximately two to three days after submission to verify posting (except allow 30 days for posting of comments submitted by mail).
For further information contact: ↑
Ms. Amy Williams, 703-602-0328.
Supplementary information: ↑
I. Background ↑
This interim rule amends DFARS 225.7002-2 to implement section 847 of the National Defense Authorization Act for Fiscal Year 2011 (Pub. L. 111-383). Section 847 provides a nonavailability exception to the requirement at 10 U.S.C. 2533a (Berry Amendment) to acquire only domestic hand or measuring tools. The nonavailability exception was previously limited to the items covered in 10 U.S.C. 2533(b)(1).
II. Executive Order 12866 ↑
This rule was not subject to Office of Management and Budget review under Executive Order 12866, dated September 30, 1993. This rule is not a major rule under 5 U.S.C. 804.
III. Executive Order 13563 ↑
In accordance with Executive Order 13563, Improving Regulation and Regulatory Review, dated January 18, 2011, DoD has determined that this rule is not excessively burdensome to the public and is consistent with DoD's requirement to acquire domestic hand or measuring tools unless an authorized exception applies.
IV. Regulatory Flexibility Act ↑
DoD does not expect this rule to have a significant impact on a substantial number of small entities within the meaning of the Regulatory Flexibility Act, 5 U.S.C. 601, et seq., because the rule allows purchase of hand or measuring tools from foreign sources only when such tools are not available from domestic sources. If no domestic sources produce the tools, then allowing purchase from a foreign source will not impact any U.S. small business. Therefore, an initial regulatory flexibility analysis has not been performed.
DoD invites comments from small business concerns and other interested parties on the expected impact of this rule on small entities.
DoD will also consider comments from small entities concerning the existing regulations in subparts affected by this rule in accordance with 5 U.S.C. 610. Interested parties must submit such comments separately and should cite 5 U.S.C. 610 (DFARS Case 2011-D025) in correspondence.
V. Paperwork Reduction Act ↑
The rule does not impose any information collection requirements that require the approval of the Office of Management and Budget under the Paperwork Reduction Act, 44 U.S.C. chapter 35.
VI. Determination To Issue an Interim Rule ↑
A determination has been made under the authority of the Secretary of Defense, that urgent and compelling reasons exist to publish an interim rule prior to affording the public an opportunity to comment. This interim rule implements section 847 of the National Defense Authorization Act for Fiscal Year 2011. This requirement became effective upon enactment, January 7, 2011. This action is necessary in order to enable contracting officers to acquire hand or measuring tools that are not available from domestic sources. Comments received in response to this interim rule will be considered in the formation of the final rule.
List of subjects in 48 cfr part 225 ↑
Government procurement.Ynette R. Shelkin, Editor, Defense Acquisition Regulations System.
Therefore, 48 CFR part 225 is amended as follows:
Part 225—foreign acquisition ↑1. The authority citation for 48 CFR part 225 continues to read as follows:
41 U.S.C. 1303 and 48 CFR chapter 1.2. In section 225.7002-2, the introductory text of paragraph (b) is revised to read as follows: 225.7002-2 * * * * *
(b) Acquisitions of any of the items in 225.7002-1, if the Secretary concerned determines that items grown, reprocessed, reused, or produced in the United States cannot be acquired as and when needed in a satisfactory quality and sufficient quantity at U.S. market prices. (See the requirement in 205.301 for synopsis within 7 days after contract award when using this exception.)* * * * *